Updated 22 September 2008
16"/50 (40.6 cm) Mark 7 Gun being lifted
aboard USS Iowa BB-61 in 1942
Note the other guns waiting to be hoisted
U.S. Naval Historical Center Photograph
# K-513
A forward turret being constructed aboard
USS Iowa BB-61 in 1942.
Note the 0.75 in (1.9 cm) STS steel plates
making up the gun house sides. To this will be bolted 9.5 in (24.1
cm) Class A armor plates. The turret back was 0.75 in (1.9 cm) STS
over which was 12.0 in (30.5 cm) of Class A armor plate. The turret
face, not yet in place in this photograph, was made up of 2.5 in (6.4 cm)
STS steel over which was 17.0 in (43.2 cm) of Class B armor plate, equivalent
to a single plate 18.75 in (47.6 cm) thick. The turret roof was 0.75
in (1.9 cm) STS over which was 7.25 in (18.4 cm) of Class B armor plate.
Note the tower foremast in the background.
U.S. Naval Historical Center Photograph
# K-515
16"/50 (40.6 cm) components
From left to right: Liner, A tube,
jacket and hoops
Open 16"/50 (40.6 cm) Mark 7 breech on
USS Missouri BB-63
Note the staggered threads, typical of
a Welin Breech design
U.S. Naval Historical Center Photograph
# 80-G-K-4558
USS Wisconsin BB-64 in March 1952
Note the 40 mm Bofors atop Turret II and
that the forward Mark 37 secondary director is facing astern
U.S. Naval Historical Center Photograph
# 80-G-441039
USS Wisconsin BB-64 in January 1952
The same guns as in the above picture
firing a salvo off Korea
U.S. Naval Historical Center Photograph
# 80-G-K-12103
16" (40.6 cm) powder bags and projectile
during open house aboard USS New Jersey BB-62 in 1968
Note the 5"/38 (12.7 cm) projectile and
propellant casing on the left
U.S. Navy Photograph
Loading a powder bag into a scuttle on USS Iowa BB-61
Loading projectiles on USS Missouri BB-63
in 1951
U.S. Naval Historical Center Photograph
# NH 96784
Inside the barbette of USS Iowa BB-61 after
her recommissioning in the 1980's
The Petty Officer is removing the fuze
protective cap from an HC Mark 13. Note the capstan at his feet,
used for parbuckling (moving) the projectiles to the shell hoists.
Parbuckling an HC round on USS New Jersey BB-62
Loading and ramming a HC round into a 16"/50
(40.6 cm) gun on USS Iowa BB-61 on 14 December 1986
The "1,000 USS IOWA" stencil is a reference
to this particular projectile being the 1,000th round fired by Iowa's 16
inch (40.6 cm) guns since the ship's recommissioning
The gauntlet on the gunner's left arm is used to wipe down the gas check pad when the breech opens. Note from these photographs that the rammer goes through the projectile bucket, that the projectile is delivered vertically and then tipped horizontally in the gunhouse, that the breech plug opens downwards and that the rammer tray is hinged. Red stripe on the left bulkhead indicates the limit of the gun recoil.
The propellant bags are delivered by the powder hoist to the door on the left, which opens to provide a ramp down which the bags are rolled, three bags at a time. In the right photograph, the gunner is pointing to the door to indicate that he is ready for the next three bags, which will be interspersed among the first three bags. All six bags were normally rammed together into the breech with a single rammer stroke, but during testing during the 1980 deployments, bags were occasionally rammed three at a time. The red quilted primer patch on the end of each bag holds the black powder igniter. The bags in this photograph appear to be reduced charge bags, which are smaller than full charge bags. Full charge bags may be seen in the photographs above.
The arrangements for the 16"/45 (40.6 cm) Mark 6 guns used on the North Carolina BB-55 class and South Dakota BB-57 class were nearly identical.
Cross-section of HC Mark 13 projectile
The overall length given in this sketch
is incorrect, it should be 60.18" (152.86 cm). 64.00" (162.56 cm)
was the length including the nose fuze.
Note that the case wall thickness is greater
than 3" (7.6 cm)
USS New Jersey BB-62 off Australia in 1990
Picture Courtesy of Mick Morris
USS Missouri BB-63 in 1950 firing on Chongjin,
North Korea
U.S. Naval Historical Center Photograph
# K-12603
USS Missouri BB-63 firing in the 1980s
Photograph courtesy of Herbert Fahr, President
of USS Missouri Association
USS Missouri BB-63 firing Tomahawk Cruise
Missile
Photograph courtesy of Herbert Fahr, President
of USS Missouri Association
Looking up at Turret II on USS Missouri
BB-63
Picture copyrighted by Jed Clear
Ceremonial honor guard prepares to render
a 21-gun salute at the 59th anniversary ceremony of the end of World War
II aboard the battleship USS Missouri BB-63 Memorial on 2 September 2004
Sailor nearest the camera is holding an
M-14 rifle
U.S. Navy Photograph 040902-N-3019M-014
Model of USS Montana BB-67 in 1941
Note the lack of AA weapons in this pre-war
model
U.S. Naval Historical Center Photograph
# NH 93912
Deactivated Mark 23 Nuclear Projectile
now at the National Atomic Museum in Albuquerque, New Mexico
Photograph copyrighted by Department of
Energy
Projectile stowage USS Alabama BB-60
Although this picture is of a ship that
carried the 16"/45 (40.6 cm) Mark 6, not
the 16"/50 (40.6 cm) Mark 7, it is noteworthy as both weapons used the
same projectiles. The nose cap for protecting the fuzes is missing
from these HC projectiles.
Photograph copyrighted by Michael Fahlman
Disassembled "Gunfighter" saboted projectile
of the late 1960s
From left to right: Front Rider,
supporting sabot, 280 mm (11") projectile, and obturator
|
|
Image and data courtesy of United States
Naval Fire Support Association (USNFSA)